Set Clutch Parts BMW M5 M6 SMG III
579,83 €
plus Shipping Costs
Set of clutch parts contains:
- Two pressure plates
- Friction plate
- Release bearing
We sell only Sachs or LUK components, both are original suppliers for BMW.
- Condition: New
- Compatible vehicles: BMW E60 M5, BMW E61 M5, BMW E63 M6, BMW E64 M6
In stock
Related Products

Hydraulic Pump Seal Kit BMW E60 M5 E63 M6 SMG III
- Seal kit for the hydraulic pump of the M5 / M6 SMG III
- Damaged or hardened seals may cause the pump to be unable to build up pressure
- Precisely fitting seals made of high-quality material

Clutch Solenoid Valve BMW E60 M5 E63 M6 SMG III
The clutch solenoid valve is located next to the pump at the driver’s side of the gearbox and is responsible for the clutch actuation of the SMG system. A faulty valve can cause problems while engaging the clutch (for example shuttering) and in consequence the car refuses to change gears. This is a factory-new spare part.

Pressure Sensor BMW E60 M5 E63 M6 SMG III
The pressure sensor measures the hydraulic pressure in the accumulator. Based on this value, the SMG enables and disables the hydraulic pump to fill up pressure. This is a brand-new original part.

Pressure Accumulator BMW E60 M5 E63 M6 SMG III
The pressure accumulator is responsible to store the pressure of the hydraulic system for later access by the actuators. This piston type accumulator has two cells: one cell storing the hydraulic fluid and one cell containing a Nitrogen gas filling which creates the counterpressure. Both cells are separated by a moving piston. Typical symptoms of a faulty pressure accumulator are frequent and short pump cycles. If there is no more preload pressure left in the accumulator, the pump runs every few seconds, which ultimately leads to a consequential damage of the pump motor. Along with the pump motor, a faulty pressure accumulator is one of the most common causes of pressure build-up issues and is one of the few wear parts in the system that should be regularly checked and replaced if necessary.
The replacement part we offer is a brand-new OE upgrade with improved internal piston seals, resulting in significantly increased durability.

Temperature Sensor BMW E60 M5 E63 M6 SMG III
The temperature sensor is located on the hydraulic unit of the M5 / M6 SMG III and measures the temperature of the hydraulic fluid. Due to its location in a high temperature area, the sensors suffers often from damage and is a common problem.

Gear Position Sensor Repair Harness BMW E60 M5 E63 M6 SMG III
New wiring harness to repair the gear position sensor strip located on top of the gearbox. Roughened or frayed cables are a common problem with this wiring harness. When the insulation of the cables is broken, short circuits occur, which lead to various SMG malfunctions and error messages (for example 4F80, 4F82, 4F85). Our wiring harness repair kit is supplied with a ready-made original BMW connector.

Pump Relay BMW E60 M5 E63 M6 SMG III
The pump relay is responsible to turn on / off the hydraulic pump of the SMG system. A broken relay causes the pump to fail priming. Without hydraulic pressure, the system cannot engage the clutch or change gears.
Pictures shown are for illustration purpose only. The relay in your car may have a different color.

VANOS Timing Solenoid Valve BMW E60 M5 E63 M6
New solenoid valve for M5 / M6 VANOS system. There are 4 of these valves on the VANOS unit.
- Applies to SMG and manual gearbox
- Comes with a new o-ring for mounting.
Your wanted part is not listed in the shop? Maybe we can repair it. Have a look at our repairs section!